| 1. | Failure analysis of the fastening bolt of the valve on the gas tower
储气塔阀门紧固螺栓的断裂分析 |
| 2. | Crosshead shoe fastening bolt
十字头滑块螺栓 |
| 3. | Fastening bolt , binding bolt
紧固螺栓 |
| 4. | Fix control units with m4 bolt on the fitting position inside distributor , and then fasten bolt
将控制组件用m4螺钉固定在分电器内侧的装配位置上，然后紧固螺钉 |
| 5. | Fix control units with m4 bolt on the fitting position inside distributor , and then fasten bolt
将控制组件用m4螺钉固定在分电器内侧的装配位置上，然后紧固螺钉； |
| 6. | Install the assembly sensor on the distributor support seat assembly , regulate the clearance between sensor and rotor up to requirement , and then fasten bolt
将总成传感器安装在分电器支承座总成上，调整转子与传感器间隙符合规定后，紧固螺钉 |
| 7. | Install the assembly sensor on the distributor support seat assembly , regulate the clearance between sensor and rotor up to requirement , and then fasten bolt
将总成传感器安装在分电器支承座总成上，调整转子与传感器间隙符合规定后，紧固螺钉； |
| 8. | Install the electronic ignition control module on the shell of distributor , fasten bolt , and then put on protective cover on sensor and electronic ignition control module
将电子点火控制模块安装在分电器壳体上，紧固螺钉，然后给传感器及电子点火控制模块罩上防护罩 |
| 9. | Fsb series fluoroplastic alloy pump is composed of pump body , impeller , back cover , seal , support , pump shaft , bearing , coupling , fasten bolt , nut and base plate
Fsb系列氟塑料合金泵由泵体、叶轮，后盖，密封性，支架，泵轴，轴承，连轴器，吊紧螺栓，螺母，底板组成。 |
| 10. | Install the electronic ignition control module on the shell of distributor , fasten bolt , and then put on protective cover on sensor and electronic ignition control module
将电子点火控制模块安装在分电器壳体上，紧固螺钉，然后给传感器及电子点火控制模块罩上防护罩； |
